![]() ![]() We made the mistake of paying them and not holding out some until the job was done…….never again! My question is, would you be able to find us some help getting this done…….we don’t know who to turn to. The owner was here last Friday and promised he would be here Wednesday, Thursday and Friday this week……needless to say that hasn’t happened. The problem is, we are having a problem getting them to come back and finish the jacking. Sump pumps were installed and a dehumidifier. I think the cause of a lot of the problem was water standing under the house. We have had a company called Fivestone Foundations come and do a lot of work…….putting in new joists, though I’m not sure all of it was done. Our floors are all tiled, so it added more weight. Our house has the heat in the floor and I don’t think the contractor knew what he was doing when he poured the concrete over it. I’ll admit, this is probably not the job for a first time do-it-yourselfer, but folks with a little experience and confidence can easily repair the sagging floors in their homes. #HANDY NOTE BROKEN SHORE PRO#Total, this job cost my brother $150-$200, where a pro would easily have charged $800-$1000. These can include pet food delivery for clients pets, home repair services. #HANDY NOTE BROKEN SHORE CRACK#By yelling through the floor to my brother’s wife, we were able to coordinate our slow turning of the screw jacks until the crack between the floor and the base board was gone. However, it is important to note that in many areas of the country. Then we kept turning until it was in contact with all four of the joists (the lower two lifted up to be in line with the higher two). With the beam resting nicely on the jacks, we slowly turned the red handles until the beam was in contact with two of the joists. After they were in place, we hoisted up the 4″圆″x8′ beam so that it crossed all four of the new joists, sliding the screw jacks underneath. Once the new joists were up, we found locations where the concrete blocks could sit flat on the ground so the pressure wouldn’t cause them to crack. The new joists are attached to the old joists and are supported by the 4×4’s and screw jacks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |